36
CALIBRATION
4. Once the system acquires the target an arrow indicates the
direction to rotate the target/wheel. The initial rotation is 25º
forward.
5. If the tire and wheel is rotated past the 25º point the meter will
change to red letting the operator know to rotate back.
6. Once the wheel has reached the desired location a stop sign
will appear in the center of the wheel. Hold the wheel steady
as the aligner will take a reading.
7. After the readings have been taken the screen instructs with
arrows indicating to rotate the wheel and target back 90º. This
90 degrees is from the rst 25º forward, rotate the tire back
until a stop sign appears as in step 6 and hold the wheel steady
as another reading will be taken.
8. After the readings are taken the arrows indicate to rotate the
tire and wheel assembly forward 90º. Rotate the wheel until a
stop sign appears and hold the wheel steady as a reading will
be taken.
To Next Page
Loading...
