Snap-On Ultra User Manual

42
CALIBRATION
6. The <NEXT> button will illuminate once the
target has been acquired. Click on the <NEXT>
button, a check mark will appear prompting the
user to proceed to step 2.
7. Proceed with calibration, until all three steps
have been completed.
8. Should calibration of the ride height target
fail, a warning dialogue box will pop up and
the user must begin the process from the
beginning. After the process completes the
3rd step the software auto advance to the
main menu.

Snap-On Ultra Specifications

General

Brand	Snap-On
Model	Ultra
Category	Diagnostic Equipment
Language	English