ITALIANOENGLISH
36
IOMMASIPXX09-GB 04
10-40 kVA
MASTERYS IP+
MENU
8
8.4 “PARAMETERS” MENU
Displays only the con guration parameters set for the UPS.
The messages in this menu are identi ed by an asterisk in the con gurations service menu.
The parameters can only be changed by entering the service / con gurations menu.
CURRENT DATA menu
Message Description
MASTERYS 3/3 30 KVA Displays the size, input and output phases con guration and the serial number of UPS.
UC FW. REVISION IIdenti es the software release of microprocessor
RV 000 CKS: 0000
DSP FW. REVISION Identi es the software release of DSP.
RV 000 CKS: 0000
8.5 “SERVICE” MENU.
This is used to change the con guration parameters, insert the warranty activation code and display the service
code.
8.5.1 “Activation code” menu.
During activation of the equipment a warranty activation code, made up of four characters, is requested to com-
plete the start-up procedure.
MANUFACTURER WARRANTY
VALIDATION
PLEASE INSERT THE CODE
The activation code is provided directly by the reference Support Centre upon communication of the serial number
of the equipment which is displayed in the next message by pressing ENTER.
SEE INSTALLATION MANUAL
FOR PROCEDURE
SN: 0000000000
When contact is made with the Support Centre for the activation code, detailed information can be obtained on the
UPS functions available and on the periodic preventive maintenance programmes.
To Next Page
Loading...
Need help?
General