11 DIRECT
ACTION
KEYS
This section refers
to the action keys, which
apply previously set up
parameters to
the cell,
as soon as they
are pressed.
11.1
ON/STANDBY
> >
Remote
command is PW/, Refer
to
Chapter
4,
Section 6.1.
Controls connections
to three of the cell terminals:
CE, RE1 and RE2.
/on/ all connections
made and polarisation drive
applied, in a sequence
determined
by what has been
selected for the I MEASURE
{STANDBY} and {ON
MODE} menus.
/standby/ connections
isolated, as determined
by what has been selected
for
the I MEASURE {STANDBY}
menu.
11.2 PSTAT/GSTAT
> >
Remote command is PO/.
Refer to Chapter
4,
Section
6.1.
Selects potentiostatic or galvanostatic
cell drive.
11.3
!R COMP/RPC
>>
Remote command
is CCI. Refer
to Chapter
4,
Section 6.8
&
6.1
1.
In potentiostatic
mode, this key is
three-state and selects IR Compensation,
or
Real
Part Correction (as
set up via the IR COMP/RPC
menu), or neither. In
galvanostatic
mode the
key becomes two-state,
selecting RPC or ’off.
11.4
LIMIT B’WIDTH
> >
Remote
command is SY
/.
Refer
to Chapter
4,
Section 6.4.
Applies
the reduced
bandwidth operation
(as set up via the BANDWIDTH
menu)
to the cell drive
amplifier. With limit
bandwidth ’ON’ (LED
illuminated) the
bandwidth
setup via the BANDWIDTH
menu will
be used.
With
limit bandwidth
’OFF’ a default bandwidth
type C is used.
3.30 JWS / S1 1 287 User
Guide /
Issue
AF
To Next Page
Loading...