43
Copyright © 2005 - 2014 Somfy SAS. All rights reserved. Non contractual images
EN
2. 1. 4. Mounting the tube-drive assembly
1) Fit and attach the tube-drive assembly to the end
support f and the drive support g.
1
place on the end support. This operation prevents
the tube-drive assembly from coming out of the end
lower end limit.
2)
ring h.
2. 2. WIRING
Cables routed through a metal internal wall must be
protected and insulated by sleeving or sheathing.
Secure the cables to prevent any contact with
moving parts.
1
1
prevent water from entering the drive!
- Switch the power supply off.
- Connect the drive according to the information provided
Cable
Neutral
(N)
Live
(L1)
Live
(L2)
Earth (
)
230 V
50 Hz
Blue Brown Green-yellow
2. 3. SET-UP
2. 3. 1. Checking the rotation direction
1)
-
correct and set-up is complete.
the next step.
2) Switch the power supply off.
-
the control point.
3)
-
1)
2)
h
g
f
L ≤ 50 m
230 V 50 Hz
N L1 L2
OFF
1)
2)
3)
ON
ON
OFF
OK
2
OK
To Next Page
Loading...
