SOMFY Oximo WT - Tips and Advice on Installation; 7 Kh

45
Copyright © 2005 - 2014 Somfy SAS. All rights reserved. Non contractual images
EN
2. 3. 2. 4. 


end limits must be set using the control point.
Setting the upper end limit
1)         

2)        

3) Place the roller shutter in the desired upper end
limit position.
 

4)         

Setting the lower end limit
5) Place the roller shutter in the desired lower end
limit position.
 

6) 

7)         

The lower end limit position is programmed.
2. 4. TIPS AND ADVICE ON INSTALLATION
2. 4. 1. 
Problems Possible causes Solutions
The roller
shutter rotates
in the wrong
direction.
The wiring is incorrect. 
The roller
shutter does not
operate.
The wiring is incorrect. 
The overheating protection on
the drive has been activated.
Wait for the drive to cool down.
The control point is not
compatible.

control point as required.
The roller
shutter stops
too soon.
The roller shutter is encountering


interference between the winding





The drive has been installed in a
new roller shutter.
Restore the drive to its original


The roller
shutter does
not stop at the
lower end limit.
 

The roller
shutter does
not stop at the
upper end limit.
The system for stopping the
roller shutter in the upper
position is unsuitable.


removable stops incorporated into the
guide rails or an end slat that acts as a
stop.
H

5)
3s
1)
7)
3)
3s
0.5s
0.5s
3s
3s
3s
4)
6)
2)