Chapter 5 • Navigator K2 Manager Advanced Features
55
Reversed - Check this box to cause the button to be displayed in a reversed or
pushed-in state when the button is not pushed and the normal state when the
button is pushed. The reversed state is “filled-in” for Rectangular, Radius,
Oblong, and Borderless buttons, and “Down” for Custom Buttons.
Note: This property does not apply to 3D buttons.
Secured - Check this box to require that the security code be entered before the
action (command, macro, or page link) associated with this button is run. The
security code is set using the Edit Device Properties command on the software’s
Edit menu.
Pause - Enter in this box the number of seconds for the Navigator K2 to halt
performing any actions after the button is released. This value will not usually
need to be changed from 0.
INFRARED TAB
The Infrared tab options are:
Min. Repeats - Enter in this box the number of times that the repeating part of
the IR code is sent by the remote. Some infrared receivers need a command to be
repeated a certain number of times to work properly and some may not work
properly if the command is repeated at all. Change this setting only if you are
having trouble with a command.
To Next Page
Loading...
