Navigator K2 keypad
56
Frequency - This box shows the carrier frequency of the IR code. This is set
automatically. You should not need to change this value unless directed to do so
by Technical Support.
Sustain - Check this box to control whether or not the IR code should repeat if
the button is held down. Most infrared codes will transmit continuously as long
as the button is held down, but some infrared receivers may not work properly
if the command is repeated at all. If the Sustain button is checked, the code will
be transmitted for as long as the button is held down or the Minimum Repeat
times, whichever is greater. If the Sustain button is not checked, the code will be
transmitted only the Minimum Repeat number of times regardless of how long
the button is held down.
Command Information - This information tells you what remote control or
device the IR code came from.
WAVEFORM TAB
The Waveform tab displays the waveform of a command for advanced
troubleshooting or if you would just like to see what Infrared data looks like.
To Next Page
Loading...
