SonicWall SonicWave Deployment Guide
Verifying Operation
81
Verifying SonicWave 200 series Operation
To verify that the SonicWave is provisioned and operational:
1 Log into your SonicWall firewall as an administrator (default: admin / password).
2 In the MANAGE view, navigate to the Connectivity | Access Points > Base Settings page.
3 In the SonicPoint/SonicWave Objects table, the Status column displays the <Short Product Name>
status. It might display Initializing, Updating Firmware, Writing Firmware, and Rebooting. After
rebooting, the Status should display Operational.
4If the Status displays Operational (Not Licensed) and does not change to Operational soon, contact
SonicWall Support for assistance with licensing the SonicWave.
5 Connect a client device to the SonicWave by selecting the appropriate access point name (SSID).
6 Ensure that the client device is not connected to any other network connections (wired LAN, 3G/4G
WWAN).
7 In a browser, enter “https://www.sonicwall.com/” in the address bar and press Enter. The SonicWall
website should display. If you are unable to browse to a website, refer to Troubleshooting.
To Next Page
Loading...
