Sonicware LIVEN MEGA SYNTHESIS - Setting Knob Movement Behavior

System settings
101
Setting knob movement behavior
1
Press
+ to set whether or not latching is used for knob
operation.
Latch
OFF Jump
When a knob is moved,
the parameter changes
immediately.
ON Latch
The knob does not a󱐯ect
the parameter value until its
position reaches that value.
Then, the value follows the
knob.
・ When set to Latch, the dots on the display will be animated to
show how much the knob position and parameter value di󱐯ers
to the left or right.
The dots will appear to ow to the left when the parameter
value is lower than the knob position and to the right when
the value is higher than the position. The ow will be faster for
higher values.