FM EDIT mode (Edit) - Setting the operator -
35
SSG-EG
SSG-EG is a special envelope waveform that can be used like a
complex LFO by repeating, inverting, and holding the envelope.
When SSG-EG is set, AR（Attack Rate） is xed at 31, and DR（Decay
Rate）, SL（Sustain Level）, and SR（Sustain Rate） adjust the EG
operation during note-on.
The operation of each knob changes depending on selected SSG-EG
type.
Setting SSG-EG
1
Press to select operators.
2
Press .
OFF
OFF -
｜＼｜＼｜＼｜＼ Repeat
During note-on, the envelope set by DR, SL, and SR
repeats between TOTAL LEVEL-0.
｜＼＿＿＿ Hold(MIN)
During note-on, when the envelope set by DR, SL, and
SR ends, the volume will be held at 0.
｜＼／＼／ Repeat(alternate)
During note-on, the envelope set by DR, SL, and SR
repeats between TOTAL LEVEL and 0.
From 0 to TOTAL LEVEL, the EG waveform will be
inverted.
｜＼｜￣ ￣ Hold(MAX)
During note-on, when the envelope set by DR, SL, and
SR ends, the volume will be held at the volume set by
LEVEL.
／｜／｜／｜／ Inverted repeat
During note-on, the inverted envelope set by DR, SL,
and SR repeats between TOTAL LEVEL-0.
／￣￣￣ Invert hold(MAX)
During note-on, when the inverted envelope set by DR,
SL, and SR ends, the volume will be held at the volume
set by LEVEL.
／＼／＼
Inverted repeat
(alternate)
During note-on, the inverted envelope set by DR, SL, and
SR repeats between TOTAL LEVEL-0.
From 0 to TOTAL LEVEL, it becomes a normal EG
waveform.
／｜＿＿＿ Invert hold(MIN)
During note-on, when the inverted envelope set by DR,
SL, and SR ends, the volume will be held at 0.
To Next Page
Loading...
