Sonoscape E1 User Manual

3 Preparing the System
Basic User Manual 31
4. Set Default Printer to Windows Printer, input the IP address of the desired
computer, and set the Printer Port Number to 6050.
NOTE:
• IP address of the computer and the system should be set in the same network
segment.
• Ensure that a printer is available for the computer.
5. Click Apply.
The printer can work without any configurations.
■ USB Printer
Perform the following steps.
1. Connect the system to the USB printer by using a USB cable.
2. Copy the file deskjet.ppd provided by the manufacturer to the USB drive.
3. Insert the USB drive into the USB port of the system.
4. Press the Setup key to enter the System Settings screen and click Peripheral >
Basic.
5. Set Default Printer to USB Printer, and click Adding Printer to connect. The
printer can be used after successfully connected.

Sonoscape E1 Specifications

General

Type	Portable Ultrasound System
Display	15-inch LCD
Transducer Ports	2
Cine Loop	Yes
Imaging Modes	Color Doppler, Power Doppler
Applications	Obstetrics, Gynecology, Vascular, Musculoskeletal
Probe Connectors	2
Ports	VGA, USB, Ethernet
Supported Probes	Convex, Linear, Phased Array