Sontex Supercal 531 - 10. Seals and Operating Modes; 10.1 Sealing Concept; 10.2 Test and Parameterisation Mode

Manual Integrator Supercal 531 06-06-2011
10.
Seals and Operating Modes
Generally, the Supercal 531
is set to normal
ware allows
the following operating modes
 Test mode (D
amaging the seal
 Parameterisation mode (
Damaging the seal A)
 Calibration mode (
Damaging the verification seal B)
The integrator is parameterised
ex
The factory-set parameters can
only
official calibration regulations.
10.1 Sealing c
oncept
The sealing concept
is submitted to
are designed-in
as shown in the picture below
10.2 Test
and parameterisation
To access the test mode, the
integrator
integrator base part you will find
To activate the test
and parameterisation
pears on the display of the
Supercal 531
display.
The jumper has to be removed
after the test
automatically.
The following parameter
can be
 set date and time
 enter customer number
 enter primary address
As soon as the jumper
is removed, the Supercal 531 goes back to normal mode automatically
With the software Prog 531
via the optical interface and depending on the user
of parameters can be set.
B
A
Seals and Operating Modes
is set to normal
mode. Apart fro
m normal mode, the integrator sof
the following operating modes
:
amaging the seal
A)
Damaging the seal A)
Damaging the verification seal B)
ex
factory according to the local regulations.
only
be changed by authorized personnel taking into account the
oncept
is submitted to
the local regulations. The sealing points
of the Supercal 531
as shown in the picture below
.
and parameterisation
mode
integrator
upper part has to be removed.
On the
the jumper connection point JP1.
and parameterisation
mode, a jumper
has to be plugged in
Supercal 531
and the test results
can be readout on the
after the test
. Then the Supercal 531
goes back to normal
can be
modified over the operator keys:
is removed, the Supercal 531 goes back to normal mode automatically
via the optical interface and depending on the user
A
58
Seals and Operating Modes
m normal mode, the integrator sof
t-
be changed by authorized personnel taking into account the
of the Supercal 531
On the
main board of the
has to be plugged in
. The test menu ap-
can be readout on the
high-resolution
goes back to normal
mode
is removed, the Supercal 531 goes back to normal mode automatically
.
via the optical interface and depending on the user
rightsa big amount