If
dust
or
debris enters the camera and lands on the image sensor (the part
that acts as the film), it may appear on the photo image, depending on the
shooting environment.
If
there is dust
on
the image sensor, use a
commercially available blower and clean the image sensor following the
steps below. You can easily clean the image sensor using only the blower
and the anti-dust function.
Notes
• Cleaning can be performed only when the battery level is
~
II~I
(three remaining
battery icons) or more. Low battery power during cleaning can cause damage to the
shutter. The cleaning should be completed quickly. The use
of
an AC Adaptor/
Charger (not supplied) is recommended.
• Do not use a spray blower because it may scatter vapor inside the camera body.
1
Confirm
that
the
battery
is
fUlly
charged
(page
17).
2
Press
the
MENU
button,
then
select
~
3
with
"/~
on
the
controller.
MENU
button
3
Select
[Cleaning
mode]
with
./T
on
the
controller,
then
press
the
center
of
the
controller.
The message "After cleaning, tum
camera off. Continue?" appears.
4
Select
[OK]
with.
on
the
controller,
and
press
the
center
of
the
controller.
After the image sensor vibrates for a short time, the mirror
in
front
is
lifted.
32
If
dust
or
debris enters the camera and lands on the image sensor (the part
that acts as the film), it may appear on the photo image, depending on the
shooting environment.
If
there is dust
on
the image sensor, use a
commercially available blower and clean the image sensor following the
steps below. You can easily clean the image sensor using only the blower
and the anti-dust function.
Notes
• Cleaning can be performed only when the battery level is
~
II~I
(three remaining
battery icons) or more. Low battery power during cleaning can cause damage to the
shutter. The cleaning should be completed quickly. The use
of
an AC Adaptor/
Charger (not supplied) is recommended.
• Do not use a spray blower because it may scatter vapor inside the camera body.
1
Confirm
that
the
battery
is
fUlly
charged
(page
17).
2
Press
the
MENU
button,
then
select
~
3
with
"/~
on
the
controller.
MENU
button
3
Select
[Cleaning
mode]
with
./T
on
the
controller,
then
press
the
center
of
the
controller.
The message "After cleaning, tum
camera off. Continue?" appears.
4
Select
[OK]
with.
on
the
controller,
and
press
the
center
of
the
controller.
After the image sensor vibrates for a short time, the mirror
in
front
is
lifted.
32
To Next Page
Loading...
