35
311 COMPOSITE (xxCH): Select the format of a composite or Y/C signal.
Notes
•Even when selecting AUTO, also select the NTSC, PAL, or PAL-M format.
•If there is no input connector or decoder corresponding to a format, that format will not be
selectable (the cursor will skip over that entry).
•When the BKM-21D is attached, changing the signal format of a channel from SDI to
COMPOSITE AUTO may prevent proper display of the picture. In this case, set the format
to NTSC or PAL first, then change to AUTO.
•When inputting the PAL-M YC signal to a channel with the BKM-26M attached, setting the
signal format to YC AUTO may prevent proper display of the picture. Set the format to
PAL-M (S or D).
AUTO: The format of the input signal is detected and switched automatically.
2)
NTSC: SETUP 7.5 or 0.
PAL: S (simple) or D (delay).
PAL-M: S (simple) or D (delay).
SECAM
2) It will take a few seconds to detect the format of an input signal when AUTO is selected. It is
recommended that a particular format be selected if it is determined.
312 COMPONENT (xxCH): Select the component signal format, or RGB.
YUV SMPTE/EBU-N10
YUV BETACAM: SETUP 7.5 or 0.
RGB
313 SDI (xxCH): Select the format of the serial digital signal.
AUTO: The format of the input signal is detected and switched automatically.
1)
NTSC: SETUP 7.5 or 0
PAL: S (simpe) or D (delay)
4:2:2
1) • It will take a few seconds to detect the format of an input signal when AUTO is selected. It is
recommended that a particular format be selected if it is determined.
• If the serial digital signal is not properly displayed at SDI AUTO mode, re-enter the channel
number.
315 YC SEP (xxCH): Select a Y/C separation filter.
TRAP/BPF
2 LINES COMB
3 LINES COMB
320 SCREEN MODE (xxCH): Select the scan size.
4:3-NORM: Overscanned 4:3 aspect ratio.
4:3-UNDR: Underscanned 4:3 aspect ratio.
16:9-NORM: Overscanned 16:9 aspect ratio.
16:9-UNDR: Underscanned 16:9 aspect ratio.
To Next Page
Loading...
