56
(1) When fading in [a]
In the standby, press FADER until the desired fader indicator flashes.
When fading out [b]
In the recording, press FADER until the desired fader indicator flashes.
The indicator changes as follows:
FADER t M. FADER t BOUNCE t MONOTONE
(no indicator)T DOT T WIPE T OVERLAP
The last selected fader is indicated first of all.
(2) Press START/STOP. The fader indicator stops flashing.
After fade in/out ends, your camcorder automatically returns to the normal
mode.
To cancel the fader
Before pressing START/STOP, press FADER until the indicator disappears.
Note
You cannot use the following functions while using the fader. Also, you cannot use the
fader while using the following functions:
– Recording still images on a “Memory Stick” in the tape recording or recording
standby
– Tape photo recording
– Digital effect
– Interval recording
– Frame recording
When you select OVERLAP, WIPE, or DOT
Your camcorder automatically stores the image recorded on a tape. While the image is
being stored, the indicators flash fast, and the playback picture disappears. At this
stage, the picture may not be recorded clearly, depending on the tape condition.
Using the fader
START/STOP
1
FADER
FADER
To Next Page
Loading...
