EasyManua.ls Logo

Sony DHC-MD717 - Severe hum or noise;stations cannot be received.

Sony DHC-MD717
104 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
97
Symptom Cause and countermeasure
Play does not start
from the first
track.
“—OVER—” is
displayed.
Tuner (Radio)
Symptom Cause and countermeasure
Severe hum or
noise/stations
cannot be
received.
A stereo FM
program cannot
be received in
stereo.
The player is in Program or Shuffle Play mode.
m Press CONTINUE to return to normal play.
You have reached the end of the disc while pressing ).
m Keep pressing 0 or turn SELECTOR to return to the desired playback
position.
The broadcast station band (FM, MW and LW for DHC-EX880MD, FM and AM
for DHC-MD717) or frequency are not correct.
m Set the proper band and frequency (see page 13).
The antenna is not connected properly.
m Connect the antenna properly (see pages 8 to 10).
• The antenna is set up in a place with poor reception.
• The signal strength is too weak.
m Find a place (e.g., outside a window) and an orientation that provide good
reception, then set up the antenna again.
The supplied FM lead antenna may not provide good reception inside a steel
reinforced concrete or steel-frame building. If you cannot obtain good reception
even when you place the supplied antenna outside a window, we recommend
you connect an optional outdoor antenna.
Part of the antenna is folded, tied or rolled up.
m The supplied FM lead antenna receives signals along its entire length, so make
sure you extend it fully (see pages 9 to 11).
m Fasten the tip of the supplied FM lead antenna to a wall with tape or a tack (see
page 11).
Part of the antenna is tied together with the speaker cord.
m Locate the antennas as far away from the speaker cords as possible.
The supplied AM antenna has come off the plastic stand.
m Consult your nearest Sony dealer.
The system is affected by electrical equipment.
m Try turning off the electrical equipment.
The tuner is set to MONO.
m Press STEREO/MONO until “STEREO” appears in the display.
Reception is poor.
m See “Severe hum or noise/stations cannot be received” on this page and check
the antenna condition.
continued

Table of Contents

Related product manuals