Sony EV-S7000 - Recording TV programs

Recording TV
programs
TAPE SPEED
INPUT SELECT
Tip
¢ To select channels, you can
also use the number buttons
on the remote commander.
Enter the desired channel
number using the number
buttons, then press ENTER.
This section shows you how to record TV programs in the most basic
way: manual recording. With manual recording, you start the VCR
recording when the program begins, then stop it when the program ends.
The VCR also provides the following ways of recording:
¢ Manually start recording, then stop it automatically—“Recording
using the quick timer” (page 38)
Automatically start and stop recording—“Recording TV programs
using the timer” (page 41)
Automatically start and stop recording just by entering the “Plus
Code”—“Recording TV programs using VCR Plus+” (page 44)
1° turn on your TV and tune in to the VCR:
© If the TV is connected to the VCR using the S-video cable or an
audio/video cable, set the TV to video input.
¢ If the TV is connected to the VCR using only the antenna, set the
TV to the channel for the VCR.
When using a cable box, turn it on.
2 onthe operation panel, set the PCM REC LEVEL control to
“5S” and the PCM REC BALANCE control to the center.
3 mserta tape with the safety tab slid back so that the red
portion does not show.
4 Press INPUT SELECT until a channel number appears in the
VCR's display window.
6 Select the tape speed, SP (standard play) or LP (long
play), by pressing TAPE SPEED.
See “To select tape speeds” on the next page.
7 Start recording by pressing @ REC.
When the tape reaches the end, the VCR automatically rewinds it to
the beginning.
Basic Operations | 37