Sony EV-S7000 - Recording TV programs using VCR Plus+

Anis section sNOWS you another way UF WINer FECUrUllig. FECUTUNTS UdillE,
VCR Plus+. This allows you to record TV programs more easily. Just
enter the program’s “PlusCode,” and the VCR will automatically record
the program. You can preset up to eight programs within a one month
Recording TV
programs using VCR
time frame.
Plus+
Before you start...
¢ Check that the clock is set correctly.
VCR Plus +
buttons than the total recording time.
e Turn on your TV and tune in to the VCR.
When using a cable box, turn it on.
1 Press VCR Plus+.
A short beep alerts you if the clock needs
to be set.
2 Enter the desired program’s
PlusCode using the number
buttons.
If you make a mistake, reenter the
PlusCode.
Select the tape speed, SP
(standard play) or LP (long play),
by pressing TAPE SPEED.
TIMER REC
ON/OFF
4 Press ONCE, DAILY or WEEKLY
according to the following:
TAPE SPEED
To record the program
Only once
Monday to Friday at the same scheduled time
Every week at the same scheduled time
Tip
¢ If you've entered the wrong
PlusCode, press TIMER
CLEAR and start again from The recording information appears on the
the beginning. TV screen: date, program start and stop
times, channel number and tape speed.
Check that the information is correct. If it
is not, press TIMER CLEAR to cancel.
To preset another timer setting, repeat
steps 1 to 4.
44 | Basic Operations
a
Ne
ee
FSO
Pe
ONT
SEIT
TT
8
ETE
TEs
FE
te
ed
as
eos
oe
acs
Beer ST ct eee es ot
¢ Insert a tape with its safety tab in place. Make sure the tape is longer
VCR Pluse
Prescoce
( J
TAPE SPEED
(se)
Enter program & PlusCode
wsing 0-9 kos
To change tepe speed
push TAPE SPEEO
VCR Pluse
PivsCode TAPE SPEED
(12345---] 18}
Alter entering PrusCoge
bush ONCE DAILY.
It you mene a mistone
oven CLEAR
PiusCoge TAPE SPEEO
(12348---] (ery
Atter entersag PrusCode
push ONCE. OAILY
oe WEEKLY
tt you make o migtate
push CLEAR
Press
ONCE
DAILY
WEEKLY
VCR Prue
PiysCode
(923465---)
RECORDING TIME
OATE START STOP CH
W7169M 1 00m t 00m 13
TAPE SPEED
Pl
To set temee pusn TIMER
Rec To er0ee.pusn CLEAR