Sony HCD-GNV99D - Page 24

24
HCD-GNV99D/GNV111D
[DVD SERVICE MODE]
• This mode let you make diagnosis and adjustment easily by us-
ing the remote commander and TV. The instructions, diagnostic
results, etc. are given on the on-screen display (OSD).
Procedure:
1. Press
?/1
button to turn the set ON.
2. Select DVD function.
3. Press
x
button and [OPEN/CLOSE] button simultaneously
and then turn the [VOLUME] knob clockwise.
4. The message “SERVICE IN” will be displayed on the
fluorescent indicator tube and the Test Mode Menu is displayed
on the on-screen display on the TV. The model name and revision
number is displayed at the bottom of the on-screen display.
Remocon Diagnosis Menu
0. External Chip Check
1. Servo Parameter Check
2. Drive Manual Operation
3. Emergency History Check
4. Version information
5. Video Level Adjustment
Model : GNV99D_E
IF-con Ver : 00.10(0000)
Syscon Ver : 0.165
5. To execute each function, press its number by using numeric
button on the remote commander.
6. To release from this mode, press
?/1
button to turn the set
OFF.
[EXECUTING IOP MEASUREMENT]
In order to execute mirror time adjustment, the following standard
procedures must be followed.
1. In standby mode, press
x
button and [OPEN/CLOSE] button
simultaneously and the turn the [VOLUME] knob clockwise.
Remocon Diagnosis Menu
0. External Chip Check
1. Servo Parameter Check
2. Drive Manual Operation
3. Emergency History Check
4. Version information
5. Video Level Adjustment
Model : GNV99D_E
IF-con Ver : 00.10(0000)
Syscon Ver : 0.165
2. Select “2. Drive Manual Operation” by pressing the [2] button
on the remote commander. The screen will appear as below.
Drive Manual Operation
1. Servo Control
2. Track/Layer Jump
3. Manual Adjustment
4. Tray Aging Mode
5. MIRR time adjust
0. Return to top Menu
3. Select “3. Manual Adjustment” by pressing the [3] button on
the remote commander. The screen will appear as below.
Manual Adjust
1. Track Balance Adjust:
2. Track Gain Adjust:
3. Focus Balance Adjust:
4. Focus Gain Adjust:
5. Eg boost Adjust:
6. Iop:
7. TRV. Level:
8. S curve(FE) Level:
9. RFL(PI) Level:
0. MIRR Time:
? ? Change Value
[RETURN] Return to previous menu
4. Select Iop by pressing [6] button on the remote commander.