2
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous ra-
diation exposure.
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be
damaged by heat.
Flexible Circuit Board Repairing
• Keep the temperature of soldering iron around 270˚C
during repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
SAFETY-RELATED COMPONENT WARNING !!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE
WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS
WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS
MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.
Laser component in this product is capable of emitting radiation
exceeding the limit for Class 1.
This appliance is classified as
a CLASS 1 LASER product.
The CLASS 1 LASER PROD-
UCT MARKING is located on
the rear exterior.
This caution
label is located
inside the unit.
Tuner section
FM Stereo, FM/AM superheterodyne tuner
FM tuner section
Tuning range 87.5 - 108.0 MHz (50 kHz
step)
Antenna: FM Wire antenna
Antenna terminals 75 ohm unbalanced
Intermediate frequency 10.7 MHz
AM tuner section
Tuning range
Middle Eastern models: 531 - 1,602 kHz (with the
tuning interval set at
9 kHz)
Other models: 531 - 1,602 kHz (with the
tuning interval set at
9 kHz)
530 - 1,701 kHz (with the
tuning interval set at
10 kHz)
Antenna AM loop antenna,
External antenna
terminals
Intermediate frequency 450 kHz
General
Power Requirements 120 V, 220 V, or 230 - 240
V AC, 50/60 Hz
Adjustable with voltage
selector
Power Consumption
300 watts
Dimensions(w/h/d) Approx. 356 × 423 × 446
incl. projecting parts and
controls
Mass
Approx. 15.9 kg
Supplied Accessories AM loop antenna (1)
FM wire antenna (1)
Speaker cords (2)
Remote (1)
R6(size AA) batteries (2)
Video connecting cable
(1)
Design and specifications are subject to change
without notice.
To Next Page
Loading...
