Sony HCD-SX7 - Card WLAN;BT Combo

HCD-SX7/SX7B
13
2-3. CARD WLAN/BT COMBO
Note 1: Be sure to replace the complete NETWORK board and card WLAN/
BT combo at the same time. Be sure to also follow “NOTE OF RE-
PLACING THE COMPLETE NETWORK BOARD AND CARD
WLAN/BT COMBO” on page 5 during replacement.
$QWHQQDZLUHVHWWLQJ
4 screw
(BV3 u 6)
5 card WLAN/BT combo
card WLAN/BT combo
2 wireless LAN
antenna connector
(CON4)
3 MAIN board CN606
cable connector
1 filament tape
(sub material)
filament tape
(sub material)
cushion (B)
Insert only part way.Insert straight into
the interior.
connector
Insert at a slant.
connector
connector
connector
connector connector
OK NG NG
+RZWRLQVWDOOWKHFRQQHFWRU
Insert the connector straight into the interior.
There is a possibility that using this unit without
the connector correctly installed will damage it.
Note 2:
Check that the wire
is not slack.
Note 3:
Do not connect the
wire to the CON5.
SYSSET
2020/02/2722:53:44(GMT+09:00)