Sony HCD-SX7 - Power Unit

HCD-SX7/SX7B
29
2-23. POWER UNIT
3 two screws
(BV3 u 6)
3 screw (BV3 u 6)
2 connector
(CN205)
3 screw (BV3 u 6)
7
power unit
Insert only part way.Insert straight into
the interior.
connector
Insert at a slant.
connector
connector
connector
connector connector
OK NG NG
 How to install the connector
Insert the connector straight into the interior.
There is a possibility that using this unit without
the connector correctly installed will damage it.
6 Remove the
power unit
in
the direction of the arrow.
15 ± 5 mm
filament tape
(sub material)
power unit
to power unit
(CN205)
:LUHVHWWLQJ
1 Remove the wire
from the coating clip.
4 coating clip
coating clip
5 sheet (PS)
,QVWDOODWLRQSRVLWLRQRIWKHVOHHYHIHUULWHFODPS)&
sleeve ferrite clamp
(FC5)
Front side
SYSSET
2020/02/2722:53:44(GMT+09:00)