Sony HCD-SX7 - Sheet (Tuner) (SX7); Module (DAB Tuner) (DAB1), DAB Board (SX7 B)

HCD-SX7/SX7B
23
2-16. SHEET (TUNER) (SX7)
2-17. MODULE (DAB TUNER) (DAB1), DAB BOARD (SX7B)
2
flexible flat cable (9 pin) (FFC2)
(CN101)
flexible flat cable (9 pin)
(FFC2)
flexible flat cable (9 pin)
(FFC2)
ferrite core (FC4)
blue line
1
filament tape
(sub material)
filament tape
(sub material)
3
cushion (power B)
cushion (power B)
corner of the plate
TUNER board
4
shield (upper) block
6
shield (lower)
shield (lower)
(inside)
notch
notch
5
sheet (tuner)
sheet (tuner)
)OH[LEOHIODWFDEOH))&VHWWLQJ
)OH[LEOHIODWFDEOH))&VHWWLQJ
3DVWLQJSRVLWLRQRIWKHVKHHWWXQHU
to
TUNER board
(CN101)
to
MAIN board
colored line
Insert straight into the interior.
flexible flat
cable
connector
OK
colored line
Insert at a slant.
flexible flat
cable
connector
NG
+RZWRLQVWDOOWKHIOH[LEOHIODWFDEOH
When installing the flexible flat cable, ensure that
the colored line is parallel to the connector after insertion.
Note:
When pasting the cushion (power B),
cover the corner of the plate as shown
below.
terminal side
2
flexible flat cable (9 pin) (FFC7)
(CN2302)
1
filament tape
(sub material)
3
screw (BV3)
(L=6 mm)
9
screw (BV3)
(L=6 mm)
9
two
screws
(BV3)
(L=6 mm)
8
module (DAB tuner)
6
Remove three
solders.
7
coaxial connector
(F type) (CN01)
qa
DAB board
4
connector
(CN2301)
0
bracket (DAB)
5 Remove the module
(DAB tuner) block in
the direction of the arrow.
colored line
Insert straight into the interior.
flexible flat
cable
connector
OK
colored line
Insert at a slant.
flexible flat
cable
connector
NG
 How to install the flexible flat cable
When installing the flexible flat cable, ensure that
the colored line is parallel to the connector after insertion.
Flexible flat cable (FFC7) setting
flexible flat cable (9 pin)
(FFC7)
ferrite core (FC4)
blue line
to
DAB board
(CN2302)
terminal side
to
MAIN board
filament tape
(sub material)
Flexible flat cable (FFC7) setting
– Bracket (DAB) rear view –
flexible flat cable (9 pin)
(FFC7)
Note: The module DAB tuner of HCD-SX7B has been changed in the
midway of production. When replacing the module DAB tuner
with a new part, be sure to refer to “NOTE OF REPLACING
THE MODULE DAB TUNER” on page 6. The fi gure above
shows an illustration of Former DAB type.
Ver. 1.3
SYSSET
2020/02/2722:53:44(GMT+09:00)