Sony HCD-SX7 - Chassis (Sub) Block

HCD-SX7/SX7B
26
2-20. CHASSIS (SUB) BLOCK
6 Draw the CDM cable and the flexible
flat cable (24 pin) out of the groove
of the chassis (sub).
8 Draw the flexible flat cable (5 pin) out
of the groove of the chassis (sub).
7 Draw the FAN motor cable out of the hole
of the chassis (sub).
9 chassis (sub) block
:LUHVHWWLQJ
:LUHVHWWLQJ
4 two screws (BV3)
(L=6 mm)
4 screw (BV3)
(L=6 mm)
4 screw (BV3)
(L=6 mm)
3 screw (BV/ring)
(L=8 mm)
1 filament tape (sub material)
2 filament tape (sub material)
5 Remove the chassis (sub) block
in the direction of the arrow.
filament tape
(sub material)
chassis (sub)
chassis (main)
filament tape
(sub material)
chassis (main)
FAN motor
cable
SYSSET
2020/02/2722:53:44(GMT+09:00)