Sony HDC-P1 - Adjustment;Setting Items When Replacing the AT-163 APT Board

1-20 (E)
HDC-P1
1-9-3. Adjustment/Setting Items when Replacing the AT-163APT Board
The AT-163APT board stores the camera setting status and fi les. When the AT-163APT board is replaced,
contents of the reference fi le, scene fi le, lens fi le, and operator fi le are lost. Before replacing the AT-163APT
board, save these fi les in a Memory Stick Duo or another storage device.
Since the OHB fi le is contained in the CCD unit, its content is retained.
Replacement procedure
1. Store the reference fi le, scene fi le, and operator fi le in a Memory Stick Duo.
. Reference fi le (Refer to Section 4-5.)
. Scene fi le (Refer to Section 4-4.)
. Operator fi le (Refer to Section 4-2.)
2. Replace the AT-163APT board. (Refer to Section 2-7-7.)
3. Install the latest version of the fi rmware. (Refer to Section 1-10.)
4. Execute REFERENCE (ALL) on the FILE CLEAR page of the FILE menu. (Refer to Section 4-5.)
5. Execute STORE FILE on the REFERENCE page of the FILE menu. (Refer to Section 4-5.)
6. Perform “3-2. Automatic Adjustment.”
7. Perform “3-4. Video System Level Adjustment.”
8. Read the stored reference fi le, scene fi le, and operator fi le.
. Reference fi le (Refer to Section 4-5.)
. Scene fi le (Refer to Section 4-4.)
. Operator fi le (Refer to Section 4-2.)
9. Adjust the lens fi le data. (Refer to Section 4-6.)
10. Execute AUTO LEVEL on the AUTO SETUP page of the MAINTENANCE menu.
(Refer to Section 4-5.)
11. Set the serial number on the SERIAL NO page of the SERVICE menu. (Refer to Section 5-3.)