53
*1 Observe the following points.
• When you turn D.EXTENDER ON or OFF, noise may be generated. This is not a malfunction. D.EXTENDER does not operate when 4K or
2× speed format is selected.
• TALLY R, TALLY G, and TALLY Y are enabled only in standalone mode.
• When HDLA is attached, VF DETAIL, SPIRIT LEVEL INDICATOR, and FOCUS ASSIST INDICATOR do not function.
• VTR S/S is available only when using the camera as a standalone device, and adds the REC signal to the SDI signal. Pressing this button
repeatedly toggles recording on/off. While recording, the tally lamp lights in red.
• An “:N/A” suffix is displayed for disabled items.
<EARPHONE>
24
RECEIVE SELECT SEPARATE
, MIX Sets the headset audio.
SEPARATE: Set L and R separately.
MIX: Set L and R to the same settings.
INTERCOM ---, LEFT
, RIGHT, BOTH UCJ model only
When the intercom Line select / Receive MIX select
switch selected by OPERATION LINK on the
operation panel is set to MIX, menu items ENG and
PROD appear instead of this item (the setting values
are same as this item).
ENG ---, LEFT
, RIGHT, BOTH CE model: Always displayed.
UCJ model: Displayed when the intercom Line select
/ Receive MIX select switch selected by OPERATION
LINK on the operation panel is set to MIX.
PROD ---, LEFT
, RIGHT, BOTH
PGM1 ---, LEFT, RIGHT
, BOTH
PGM2 ---, LEFT, RIGHT
, BOTH
PGM3 ---
, LEFT, RIGHT, BOTH
TRACKER ---, LEFT
, RIGHT, BOTH
SIDE TONE MUTE, 1 to 99, 50
OPERATION LINK INCOM1, INCOM2 UCJ model: Selects which intercom to link to the
headset microphone on/off control, Line select /
Receive MIX switch, MIX TALK setting, and each
volume adjustment.
CE model: Selects which intercom to link to the
headset microphone on/off control and line
selection.
MIX TALK(INCOM1) or MIX
TALK(INCOM2)
ENG
, PROD UCJ model only
Displays MIX TALK(INCOM1) when OPERATION LINK
is set to INCOM1, and MIX TALK(INCOM2) when set
to INCOM2.
<OPERATOR FILE>
25
READ (USB t CAM) Execute using ENTER. Reads the operator file from a USB drive.
WRITE (CAM t USB) Execute using ENTER. Writes the current settings of the operator file items
to a USB drive.
PRESET Execute using ENTER. Sets the operator file items to the preset values in
internal memory.
OPERATION
Page name
Page No.
Item Settings Description
To Next Page
Loading...
