Sony HDC3500 - Page 92

92
<USER GAMMA>
F04
Displayed only when
HZC-UG50 series is
installed
READ (USB t CAM) Execute using ENTER. Reads the user gamma file from a USB drive.
PRESET Execute using ENTER. Sets the user gamma file items to the preset values
in internal memory.
FILE ID Max. 14 characters Enters a comment for the user gamma file to be
written to a USB drive.
See
“To specify a character string” (page 30) .
CAM CODE Camera code Display only
DATE Date Display only
<LENS FILE>
F05
STORE FILE Execute using ENTER. The center marker is not included.
No. 1 to 17, 1
1 to 16: When using a non-serial lens (When using a
large lens, this setting depends on the internal
setting of the lens.)
17: When using a serial lens
NAME Changeable only when using a non-serial lens.
F NO F1.0 to F3.4, F1.7
Changeable only when using a non-serial lens.
CENTER MARKER Sets and stores the center marker position:
H POS: Increasing the value moves the position to
the right.
V POS: Increasing the value moves the position
downwards.
H POS –48 to +48, 0
V POS –27 to +27, 0
STORE Execute using ENTER.
<OHB FILE>
F06
STORE FILE Execute using ENTER. Stores the offset values of items specific to the
CMOS image sensor (once stored, the values do not
need to be stored again if the sensor is reinstalled).
<MATRIX FILE>
F07
CUSTOM PRESET MATRIX Stores and reads preset files:
When storing a preset file in camera memory,
specify the file number.
STORE FILE Execute using ENTER.
1
2
3
4
5
CLEAR ALL Execute using ENTER. Clears all the files.
READ (USB t CAM) Execute using ENTER. Loads five preset files from a USB drive to internal
memory.
WRITE (CAM t USB) Execute using ENTER. Writes five preset files in the camera’s memory to a
USB drive.
FILE ID Max. 14 characters Enters a comment for the preset files to be written
to a USB drive.
See
“To specify a character string” (page 30) .
CAM CODE Camera code Display only
DATE Date Display only
<BOX CURSOR FILE>
F08
1: BOX CURSOR FILE selection FILE name input.
Align the cursor to the left of the number to select
the BOX CURSOR FILE.
Align the cursor to the right of the number to enter
the BOX CURSOR FILE name.
See
“To specify a character string” (page 30) .
2:
3:
4:
5:
STORE Stores a BOX CURSOR FILE name in the camera.
READ (USB t CAM) Transfers a BOX CURSOR FILE from a USB drive to
the camera.
WRITE (CAM t USB) Transfers a BOX CURSOR FILE from the camera to a
USB drive.
FILE
Page name
Page No.
Item Settings Description