4.12 ATMOS CEC Disable
1) Go to “ATMOS CEC DISABLE” and Press “” or “” button to select ‘0’ or ‘A’
2) After select the option that you wish, press “Home” to confirm the
selection.
Option Execution Effect
0 (default)
The TV checks whether HDMI1(ARC) is
connected to an amplifier that support
ARC & Atmos or not, and sets either
Atmos EDID/ Non Atmos EDID.
A
The TV skip Atmos checking when
HDMI1(ARC) is connected to an
amplifier that support ARC and set
Atmos EDID even when amplifier
doesn’t support Atmos.
ATMOS_CEC_DISABLE (EEPROM 0x30A0)
Data : [0/A] Default : 0
Purpose : Data [A] is able to skip Atmos judgment
CEC<Report Short Audio Descriptor> that comes from
the amplifier, and set Atmos EDID as the service c/m to
an amplifier that supports Atmos but it reply NO Atmos.
Remarks :
1) This data is not changed by software update or AC
off/on, only change from service menu.
2) Need to turn AC off/on after change setting in order
algorithm to take effect.
132
SYSSET
2018/05/0404:12:02(GMT+09:00)
To Next Page
Loading...
Need help?
General