EasyManuals Logo

Sony MAP-S1 Operating Instructions

Sony MAP-S1
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
21
GB
Listening to music through a BLUETOOTH connection
Once a pairing operation is performed, it does
not have to be performed again. In the following
cases, however, a pairing operation must be
performed again:
Pairing information was erased when the
BLUETOOTH device was repaired.
You attempt to pair the system with more
than 9 BLUETOOTH devices.
This system can pair with up to 9 BLUETOOTH
devices. If you pair another BLUETOOTH
device after pairing with 9 devices was
performed, pairing information of the device
that was connected with the system first is
overwritten with that of the new device.
Pairing registration information of this system
is erased from the connected device.
If you initialize the system or erase the
pairing history with the system, all the
pairing information will be erased.
The sound of this system cannot be sent to a
BLUETOOTH speaker.
“Passkey” may be called “Passcode,” “PIN code,
“PIN number” or “Password,” etc.
To check the address of a
connected BLUETOOTH device
Press DISPLAY while the name set on the
connected BLUETOOTH device is shown in
the display window. The BLUETOOTH device
address appears in the display window for
about 8 seconds.
To cancel the connection with the
BLUETOOTH device
Disconnect the BLUETOOTH connection on
the BLUETOOTH device. “BLUETOOTH”
appears in the display window.
Depending on the device, the connection
may be canceled automatically when you
stop playback.
To erase the pairing registration
information
1
Select “Delete Link” after step 3 on
“Pairing the system with a BLUETOOTH
device and listening to music” (page 20),
then press ENTER.
2
Press / to select “Ok,” then press
ENTER.
“Complete!” appears in the display window and
all the pairing information is erased.
Note
If you have erased the pairing information, you
cannot make a BLUETOOTH connection unless
pairing is performed again.
After step 1 on “Pairing the system with a
BLUETOOTH device and listening to music,
operate the BLUETOOTH device to connect
with the system, then press of the unit
to start playback.
Listening to music through
a registered device

Table of Contents

Other manuals for Sony MAP-S1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sony MAP-S1 and is the answer not in the manual?

Sony MAP-S1 Specifications

General IconGeneral
Receiver typestereo
Audio output channels2.0 channels
Power output per channel (20-20KHz@8 Ohm)100 W
HDMI in0
Audio (L/R) in1
Connectivity technologyWired & Wireless
Speakers connectivity typeBinding post
Ethernet LANYes
Supported radio bandsAM, FM
Optical drive typeCD player
Card reader integratedNo
Display-
Product colorSilver
Volume controlRotary
Apple docking compatibilityNot supported
Power consumption (standby)0.4 W
Power consumption (typical)55 W

Related product manuals