31
GB
Additional information
Setting the
BLUETOOTH/Network
Standby mode
When BLUETOOTH/Network Standby mode
is enabled, the system enters Wait mode for
BLUETOOTH or network connection even
when the system is turned off. This mode is
disabled by default.
1
Press MENU.
2
Press / to select “Standby
Mode Menu,” then press ENTER.
3
Press / to select “BT/NW
Standby,” then press ENTER.
4
Press / to select “On” or “Off,”
then press ENTER.
5
Press / to turn off the system.
When this function is set to “ON” and you
connect to the system from a BLUETOOTH or
AirPlay device, the system turns on
automatically and you can listen to music by
using the BLUETOOTH or AirPlay connection.
The system cannot be turned on by a DLNA
device or by using a Music Services connection.
Setting the wireless
signal ON/OFF
When the unit is turned on, you can control
a wireless network or BLUETOOTH signal.
The default setting is ON.
1
Turn on the unit.
2
If flashes in the display
window, press and hold PUSH
ENTER and MENU of the unit.
3
After “RF Off” (wireless signal is
off) or “RF On” (wireless signal is
on) appears, release the button.
When this setting is set to off, the wireless
network function and BLUETOOTH function are
not available.
When this setting is off, the unit is turned on by
the smartphone/tablet by one-touch action
(NFC) on the unit.
When this setting is off, the BLUETOOTH/
Network Standby mode cannot be set.
When the BLUETOOTH/Network Standby mode
is on and the unit is turned off, the BLUETOOTH/
Network Standby mode turns off.
When this setting is off, the unit and
BLUETOOTH device cannot be paired.
Even when this setting is off, a wired connection
can still be used.
To Next Page
Loading...
