Sony SA-NT5 - RF Modulator Block; RF Modulator (RF1)

HT-NT5
17
2-11. RF MODULATOR BLOCK
2-12. RF MODULATOR (RF1)
1 saranet cushion
3 two screws
(BVTP3 u 10)
2 FFC 24P
(CN701)
REPEATER board
Note:
Be careful not to damage
the REPEATER board.
4 RF modulator block
front side
right side
bottom cabinet block
RF modulator
saranet cushion
FFC 24P
:LUHVHWWLQJ
front side
left side
This side is
the terminal side.
OK NG
4 cushion (CZ2-A)
5 screw
(BTP2.6 u 6)
1 FFC 24P
2 shield (WS-antenna) block
3DVWLQJSRVLWLRQRIWKHFXVKLRQ&=$
This side is the
terminal side.
7 RF modulator
(RF1)
3 foot
6 holder (WS-J) assy
Paste the cushion (CZ2-A) so that
all of the chip parts are covered.
cushion (CZ2-A)
The chip parts are visible.
cushion (CZ2-A)
Note: When the RF modulator (RF1) is replaced, refer to “WIRELESS
CONNECTION (LINK) WORK OF BAR SPEAKER AND
SUBWOOFER” on page 7.