HT-NT5
REVISION HISTORY
Ver. Date Description of Revision
1.0 2016.03 New
1.1 2016.05 Addition of EA, BR, SP and TW models
Addition of Part for WASHER (Ref. No. 5 and 6)
Change of Part No. for INSTRUCTION MANUAL
(SMR-16002)
1.2 2016.07 Addition of CH, RU, AR and LA models
Deletion of Part for Ref. No. R5099 and R5111 on the MB-1509 board
(SMR-16009)
How to search for a contact point of signal lines or the like in DIAGRAMS SECTION
If a contact point of a BLOCK DIAGRAM, PRINTED WIRING BOARD or SCHEMATIC DIAGRAM is shown in a different page, use
the PDF fi le search function to fi nd one.
e.g.) If a contact point is shown as
, follow the procedure below.
Procedure:
1. Press the [F] key while pressing the [Ctrl] key.
2. Input “>001Z” in the search box and press the [Enter] key.
3. The relevant part (page), where the contact point is shown, appears.
Note: If you still see the original page, press the [Enter] key again.
To Previous Page
Loading...
