2-13 (E)
VPL-EX100
2-5-5. Writing of 3Dgamma/LookUpTable/Main Board Data
1. Connect the AC plug and set this unit to standby state.
2. Press the I/O button on this unit.
The lamp lights and the image is displayed.
3. Double-click QuickAccess.exe to start the application.
4. Select a target model on the Model pull-down menu.
5. Select Load on the Load/Save pull-down menu.
6 Select the data type (3Dgamma/LookUpTable/Main Board) on the 3dgm/Lut pull-down menu.
7. Click the [Next] button.
8. Click the [Browse...] button.
The fi le selection window is displayed.
9. Select the fi le to be written.
10. Click the [Next] button.
11. Select the serial port used for connecting PC on the Serial Port pull-down menu.
Upper line: Serial port number used for connecting PC
Lower line: 38400 (not selectable)
12. Click the [Next] button.
The window displaying the fi le path, model name written in fi le, unit serial, serial number model
name of this unit, and serial number is displayed.
13. Click the [OK] button.
The writing starts. Completed is displayed after completed.
14. Press the I/O button and set this unit to standby state.
15. Disconnect the AC plug.
16. Click the [Complete] button.
To Next Page
Loading...
