14.1: SNAPSHOT CONTROL
SNAPSHOTS, CUELISTS, FILTERS > CONTROLS
Preview Mode
Make the cue list available for preview via the cue selection buttons [LAST], [NEXT], [UP},
[DOWN, and [RECALL].
When Preview Mode is deactivated, the cue list will return to the cue selected before Preview Mode was activated.
Recall Last Cue
Select AND recall the previous cue in the cue list.
Recall Next Cue
Select AND recall the next cue in the cue list.
Recall Selected Cue
Recall a cue that has been pre-selected with the [UP] and [DOWN] keys
Up / Down Cue List
Pre-Select cues by scrolling up and down the cue list. Press [RECALL] to load that cue.
Isolate From Recall
Isolate ('protect') this channel or selected parameters from the effects of snapshot recall or Show
recall.
The [ISO buttons are found on the console channel strips. Isolate whole channels by pressing that channel's [ISO]
button. Isolate sections, processing blocks, and so on by holding an [ISO] key down and selecting those blocks/
sections. Any isolated channel or selection will not be aected by the RECALL of a snapshot from the cue list.
If you have 'LOAD ISO WITH SHOW' (Snapshot Setup) set to 'No' then your selections will also be isolated from a
Show load. See the Snapshots Filtering And Isolation section below for more information. In addition to its
usefulness in performance, the ISO function can also be useful for updating snapshots with new settings. For
example, you could update a channel's EQ settings, isolate it, then recall cues and 'UPDATE CUE' with the new
settings.
To Next Page
Loading...
Need help?
General
