5.5: BUTTONS OVERVIEW
OPS OVERVIEW > CONSOLE BUTTONS
[SETUP] Buttons
[SETUP] buttons open the relevant setup screen in the Master Bay Vistonics screen.
While a setup screen is active, pressing the [SETUP] button again will close that setup screen. For more informa-
tion see the chapter relevant to each [SETUP] button.
[SOLO/SEL] Buttons
Solo or select a channel.
The [SOLO/SEL] keys operate in two modes. The default function is to enable the SOLO path from its channel
or bus to the monitoring system. However, if a touch-area page is open, pressing a [SOLO/SEL] from another
channel (within its own bay of eight channels) moves the touch-area page to this new channel. [SOLO/SEL] but-
tons also perform other selection functions depending on the console mode. These are described in the relevant
reference chapter.
[GANG] Buttons
Special Ganging functionality.
For linking channels, processing blocks, and parameters, for convenient control. See the Gang section in this oper-
ations overview chapter for more information.
[SOLO CLEAR] Button
Clear any currently active console Solos.
To Next Page
Loading...
Need help?
General
