45
IMPORTANT NOTICE REGARDING EFT (Electri-
cal Fast Transient): Under environment with
electrical fast transient, the unit may mal-
function and require user to reset the unit.
Removing and then replacing the battery
will automatically reset the unit.
1. To replace the battery in the MODE
Free you will need a small Phillips
screwdriver and four and a half min-
utes. Flip the keypad over, ensuring
the battery door is facing you.
2. With your screwdriver in hand, remove
the battery door screw by turning the
screw driver counter clockwise (left)
until the screw is fully loose. Use your
fingers to remove the screw, set the
screw down for now.
3. As shown, flip the keypad over and
let the battery door fall into your
hand. Set the door next to the screw
you just removed, you will need both
of them later in the installation.
4. Flip the keypad back over. Using a
fingernail or small screwdriver, GEN-
TLY lift the battery out of the keypad,
lifting from bottom to top.
5. Remove the battery and replace with a new one.
6. Once the battery is firmly in place, find the battery door where ever you set it
down and reinstall it by angling the battery door at 36 degrees and inserting
the battery door tabs into the MODE Free battery door opening. Once tabs are
firmly in place, gently set the battery door cover down into the battery door
opening. Once the battery door is fully installed, pick up the battery door screw
and place it in the screw hole that you removed it from. Using your trusty screw
driver, turn the screw clockwise to tighten the screw. Make sure to just snug the
screw and not over tighten. Now you are ready to use your MODE Free.
NOTE: With any new battery, it is always
good practice to charge the battery fully
before use. This will help ensure longevity of
the battery’s life.
BATTERY INSTALLATION GUIDE
To Next Page
Loading...
Need help?
General
