SpeakerCraft MODE 3.1 User Manual

52
FAQ
MODE 3.1/FREE KEYPAD
1. Select Button (Click Button)
Q: Where is the Select Button?
A: See Figure 1, Page 6, Item 5.
Q: Beside select, does the Click Button have any other function?
A: Press and hold for Party Mode at Main Menu Screen.
2. Menu Button
Q: What is the basic function of the Menu Button?
A: Press once to move one menu level up. (Similar to iPod Menu Button function.)
Q: Other function?
A: Press and hold to return to Main Menu.
3. Keypad Release Button
Q: What is the Keypad Release Button for?
A: To release MODE FREE Keypad from both Wall and Table Docks.
4. Zone Power OFF Button
Q: What is the basic function?
A: Press to turn the local zone OFF.
Q: Other function?
A: Press and hold to turn all zones OFF.
5. System Info/Status
Q: On a MODE FREE Keypad, how does the user know what zone are they in?
A: The zone name will appear in the Keypad Header after 4 seconds of the system info/status.
6. Default Functions – Play, Pause, Prev, Next, FF and RW
Q: Is it necessary to program the keypad before use? Any other default functions?
A: If programming a MODE/MODE FREE for use with iPod, there are several default functions such as play, pause, pre-
vious song, next song, fast forward (UP) and rewind (DOWN) that will program by default when selecting iPod
as a source in EZ-Tools. For any other device, the play, stop, tuner, etc functions must be programmed in EZ-
Tools. The UP/DOWN and Click Buttons operate MODE/MODE FREE menu up and down and selected by default.
7. Address Switch
Q: How is a MODE Free Keypad installed without an Address Switch?
A: There is no Address Switch on MODE Free Keypad, the Address Switch is located on the Wall Dock.
8. Standby Timeout
Q: The Standby Timeout was set when keypad was docked, but the timer is not working correctly when undocked.
A: There are two types of standby timeout: docked and undocked. Each must be set individually for the Standby Time-
out to function properly in both conditions.
9. Sleep Timeout
Q: Will MODE FREE go to sleep when it is docked?
A: MODE FREE will not go to sleep when it is docked. Sleep Timeout ONLY applies to an undocked keypad.
Q: Why does the MODE FREE reset after wake up?
A: There is no communication when keypad is in Sleep Mode, so the keypad must synchronize with the MZC System
when it wakes up.

SpeakerCraft MODE 3.1 Specifications

General

Brand	SpeakerCraft
Model	MODE 3.1
Category	Keypad
Language	English