Spectra Precision DG613 User Manual

Error
codes
Description
Solution
21
Temporary EEprom problem
Repeat pairing and re
-
enter the customer
settings
120
LA
alert - Unit setup has been
changed
Check laser beam
elevation/direction
130
Mechanical Limit during
Spot Match
-
o
nly at DG813
Re
-align the closer to the alignment
point; check if existing slope is
below/above
-12% to +40%
140
Laser beam blocked
- o
nly at DG813
Make sure there are no obstacles
between the transmitter and the
SF803
141
Time Out
– Automatic alignment or
self
-leveling could not be completed
in the allowed
time
Check radio operating range/ connection;
ensure a stable
laser setup
Any error message can be deleted with a short press of the button.
The table shows the related description and possible solutions.
The next service center should be contacted if a different error message as shown at the
table will be displayed.
Troubleshooting DG813/DG613

Spectra Precision DG613 Specifications

General

Brand	Spectra Precision
Model	DG613
Category	Measuring Instruments
Language	English