Installation Information
Installation Information
Installation Requirements
Tools and Parts
Assemble the necessary tools and supplies before beginning the
washer installation. The parts supplied are in the drum.
Tools needed for installation:
Wrench, Screwdriver, 13mm Socket/Ratchet
Parts Supplied
U-Clamp Transit Bolt Hole Plugs (4)
If You Have You’ll Need to Buy
No access to Hot/Cold
water hookups
Splendide Faucet Adapter Kit, Part
No.
154187104A (8ft , 2.4m)
Vented Drying
Model
Splendide Vent Kit, Part No. VI-422, VID-
401, or similar
Water Damage
Concerns
Splendide Drain-A-Way Pan, Part No. PI-22,
PI-24, or similar
Floor Drain
Siphon break kit (Sold at hardware stores)
Disposer Drain
“Y” connector (Sold at hardware stores)
(Continued on the next page)
Location
Selecting the proper location for the washer-dryer improves
performance and minimizes noise. Proper installation is your
responsibility.
The washer-dryer can be installed under a counter, in a closet, in an
alcove, or in a recessed area with minimum installation clearances
of 0” sides, 1” front/back.
You’ll Need
• A water heater set to deliver 120°F (49°C) water to the washer
• A grounded electrical outlet located within 6 ft. (1.8 m) of
where the power cord is attached to the back of the washer. (See
“Electrical Requirements.”)
• Hot and cold water faucets located within 8ft. (2.4 m) of the hot
and cold water fi ll valves, and water pressure of 7.5-100 psi.
• A solid, level fl oor that can support at least 280 lbs. (127 kg). DO
NOT install on carpet.
• RV/Marine Installations: Position the machine over the axles
or mid-ship and block-in to prevent extreme movement.
• Vented models: Rigid or fl ex/metal dryer ducting. The washer-
dryer MUST be exhausted to the OUTSIDE. Exhaust ducts should
be as short and straight as possible and must slope downwards
and away from the machine. The exhaust duct must end with
an approved exhaust vent hood with swing out damper(s) or
tailpiece with louvers.
Check these location, plumbing and electrical installation requirements for a proper washer-dryer installation.
To Next Page
Loading...
