Sri PXS-710D - Responsibilities

To Next Page

To Previous Page

PXS-710D Section 1

1.3 CONTINUED:

 The boom arm presents a pinch hazard. Keep hands clear when in use.

1.4

RESPONSIBILITIES

 To operate X-ray equipment it is required by state/country that the operator

will be trained personnel. The operator must be familiar with safety

requirements for operating the X-ray generator.

 It is the responsibility of the operator to ensure the safety of the patient

during exposure via proper positioning of the x-ray source.

 This equipment can be hazardous to both patient and operator unless

established safe exposure factors, operating instructions, and maintenance

schedules are observed. Source-Ray, Inc. disclaims all responsibility from any

injury resulting from improper application of this equipment.

 Ensure that all personnel authorized to use the unit are aware of the danger

of excessive exposure to X-ray radiation.

 The unit herein described is sold with the understanding that the

manufacturer, its agents and representatives are NOT liable for injury or

damage which may result from over-exposure of patients or personnel to X-

ray radiation.

 The manufacturer does not accept any responsibility for over-exposure of

patients or personnel to X-ray radiation generated by this unit which is a

result of poor operating techniques or procedures.

 The manufacturer of this unit does not assume any responsibility for any

equipment that has not been serviced and maintained in accordance with the

manufacturer instructions or which has been modified or tampered with in

any way.

 It is the responsibility of the operator to ensure the safety of the patient while

the X-ray unit is in operation by visual observation, proper patient positioning

and use of the devices that are intended to prevent patient injury.