Sri PXS-710D - Procedure

To Next Page

To Previous Page

PXS-710D Section 3

3.5 OPERATING PROCEDURE: (PODIATRY SUPPORT BASE)

1) Move the Boom Arm (A) to the desired position and release, the Boom Arm

will retain the current position. The Boom Arm position range Left to Right

is from -90° to 90°. Front and back position range is -2° to +15°

2) To change the angle of the Generator/Control Assembly, Rotate the

Generator/Control Left 15° or Right 15°, Detents will hold the

Generator/Control in -15°, 0, +15° increments.

3) To change the forward tilt of the Generator/Control Assembly, push the top

of the generator back to move the X-Ray field forward. Detents are

provided at 0° and 15°.

4) To Place the Customer Supplied Digital Imaging Panel in the Vertical Panel

slot, pull on Slide Handle (G) to open Panel Slot, and insert the Digital

Imaging Panel. Remove the Digital Imaging Panel and Push on the Slide

handle (G) to Close the Panel Slot.