PXS-710D Section 2
32
CAUTION
Be certain that the primary power source (wall outlet) is the same
rating as the voltage specified on the label, located on the rear panel of
the x-ray control.
The power cord acts as mains disconnect device.
2.3 ELECTRICAL CONNECTIONS
Be certain that the primary power source (wall outlet) is the same
rating as the voltage specified on the label, located on the underside of
the Generator Assembly.
Connect the following connections at the Control/Generator Assembly. The Base
Cable Assembly attached to the Boom Arm Assembly provides connection to the
Source Base assembly (Reference Figures 3.1, 3.5, & 3.6):
1) Connect the power cord from the Base cable assembly to the power Inlet (2).
2) Connect the Remote Control Interface cable from the Base cable assembly to
the Interface connector (5).
3) Connect the Exposure Switch from the Base cable assembly to the Exposure
connector (3). Connect the RS-232 Cable from the Base cable assembly to
the RS-232 interface connector. (6) Connect the Following Source Base
connections.
4) Connect the power cord from the Base cable assembly to the power Inlet (D).
5) Optional, Connect the Remote Control Interface cable from the Base cable
assembly to the Interface connector (B).
6) Connect the Exposure Switch & the accessibility Bracket from the Base cable
assembly to the Exposure connector by reusing supplied hardware (O).
7) Connect the RS-232 Cable from the Base cable assembly to the RS-232
interface connector. (A)
To Next Page
Loading...