ST STM8L - Selecting the Correct Debug Instrument; Figure 21. STVD: Selecting the Debug Instrument

DocID16139 Rev 5 33/42
AN3029 Setting up the STM8 development environment
41
10.3.2 Selecting the correct debug instrument
In the example below, the Rlink tool is used for communicating via the SWIM interface with
the on-board debug module of the STM8.
The Rlink tool can be selected from the ‘Debug Instrument Selection’ list in the ‘Debug
Instrument Settings’ dialog (see
Figure 21).
Figure 21. STVD: Selecting the debug instrument