Setting up the STM8 development environment AN3029
38/42 DocID16139 Rev 5
The LCD display on the STM8 evaluation board indicates a successful debug session (see
Figure 26).
Figure 26. STM8 evaluation board
10.3.6 Follow up
Step by step, additional peripherals of STM8L/STM8AL devices can be run, following on
from the initial debug session described above.
Many features of STM8L/STM8AL devices are supported by dedicated hardware on the
STM8 evaluation board. The necessary software drivers, including STM8L/STM8AL
peripheral drivers (USART, ADC, SPI) and drivers for the EVAL board modules (LCD, serial
memory), are delivered in the STM8L1x firmware library.
To Next Page
Loading...
