Introduction ST700 Dash Display System
6
Safety Issues
You must take note of the following safety advice when you install the
ST700 Dash Display System on your vehicle:
Follow the instructions to attach all components of the system se-
curely to the vehicle so that they do not vibrate loose and fall off.
The wiring harness supplied with the ST700 Dash Display System
is certified for use in high temperature applications up to 105°C
(221°F). Do not substitute wires that have a lower temperature rat-
ing than this. Contact Stack for advice if you are in any doubt.
Route all wires and the wiring harness so they do not snag against
any moving parts of the vehicle.
Do not apply sharp bends or other severe stresses to the wiring
harness.
Avoid positioning the sensors or their wires close to any sources
of intense heat or vibration or close to the leads of the ignition HT
or fuel injection systems.
Use cable clips to secure the wiring harness.
Use suitable glands or grommets to protect the wiring harness
where it passes through vehicle bulkheads or panels.
To Next Page
Loading...