ST700 Dash Display System Installation
© Stack
27
❑ Do not mount the sensor closer than 75 mm (3 inches) to ignition
leads, the distributor or the ignition coil.
❑ Mount the sensor directly in the fluid line so that its end lies in
the middle of the flow of fluid.
2. Attach the sensor to its appropriate monitor point.
3. Connect the wiring harness to the sensor at the spade terminals.
Battery connection
The ST700 Dash Display System accepts power from the vehicle electri-
cal system through the two cables labelled ‘B+’ and ‘B–’ in the wiring
harness.
1. Connect the black ‘B–’ cable from the harness directly to the battery
negative terminal.
2. Connect the red ‘B+’ cable of the harness to a fused supply from
the battery positive terminal. The fuse rating for this line should be
no higher than one amp. This line should become ‘live’ only when
you switch on the vehicle ignition.
To Next Page
Loading...