ST700 Dash Display System Installation
© Stack
13
Controls
The ST700 Dash Display System includes three controls:
❑ Driver button—this is a normally–open spring–loaded switch that
closes when pressed and opens when released.
❑ Rotary control—this is a combined push button and rotary selector.
❑ Lap button (optional)—this is a normally–open spring–loaded
switch option that closes when pressed and opens when released.
For convenience, you should install the controls where the driver may
operate them easily. An ideal installation for the Driver button and for
the optional Lap button is on the steering wheel within easy reach of a
thumb.
Install the rotary control where it is possible to operate it conveniently
while viewing the ST700 Dash Display System display.
1. Drill holes or install brackets to support the controls in the locations
you have selected for them. The hole dimensions and tightening
torques are:
Rotary control: M7 clearance (7.2 mm diameter) with the control
tightened to 1.2 Nm (12 kgf.cm or 0.9 lbf.ft)
Driver button: 12.2 mm diameter with the control tightened to 1.5
Nm (15 kgf.cm or 1.1 lbf.ft)
2. Connect the correct cables of the harness to each control.
To Next Page
Loading...