Operation ST700 Dash Display System
40
ting in larger steps if you hold the Driver button while you make
this adjustment. Release the controls to set the Split 1 distance at the
displayed value, which should be the distance from the lap refer-
ence point.
6. Turn the rotary control clockwise by one step to show the current
setting for the Split 2 distance. This must always be equal to or
larger than the setting for Split 1. Press and turn the rotary control
to set the distance from the lap reference point to the second split
timing point. Release the controls to set the Split 2 distance at the
displayed value.
7. Return to the normal display mode:
❑ Turn the rotary control clockwise to show ‘Return To Last Menu’.
❑ Briefly press the rotary control to show ‘Split Timing’.
❑ Turn the rotary control clockwise until it shows ‘Return To Last
Menu’.
❑ Briefly press the rotary control to show ‘Performance Timers’.
❑ Turn the rotary control clockwise until it shows ‘Exit Menus
push button’.
❑ Briefly press the rotary control to restore the normal operating
mode.
To Next Page
Loading...