Maintenance ST700 Dash Display System
66
Disconnect the receiver and short together pins 1 and 4 on the ‘LapT’
connector. If the display changes, renew the receiver after checking
its wiring.
❑ Trackside transmitter signal swamped by an adjacent transmitter.
Move the transmitters so that they are at least 4 metres apart.
❑ Trackside transmitter obscured by pit board.
Reposition the transmitter or the pit board.
❑ Trackside infrared transmitter is not working
Connect or charge the transmitter battery
Check for a green light on the side of the transmitter
❑ Incorrect alignment of transmitter and/or receiver
Re–align the transmitter and/or the receiver
Follow user guide instructions for setup
❑ Transmitter positioned with the sun at a low angle behind it
Move the transmitter to face into the sun
❑ Water on transmitter lenses
Remove water from the lenses. Fit a protective cover.
Shield lenses with a cover in all wet conditions.
To Next Page